Browse our Blog items for tips and information on Siemens PLM products
This video takes you through how to create a hopper (that can be flattened) in Solid Edge sheet metal using synchronous technology. 587 total views, no views today
587 total views, no views today
Synchronous Technology can give big benefits in modelling sheet metal to allow you to quickly design from the ground up and none more so that when some of your flanges are at an angle. I was asked recently how to have two flanges that were not at the traditional perpendicular (90°) measure the same from
785 total views, no views today
Creating a slot in Solid Edge is very easy. One method would be to construct it with circles and tangent lines and then trim out the internal sections of the circles. This works OK, but you need to constrain the geometry well with relationships and dimensions to keep it as you would require it. 849 total
849 total views, no views today
When you you are in the draft environment, it is possible to use callouts to label the bend direction, bend angle, etc using special callout labels. 502 total views, no views today
502 total views, no views today
Creating and Using The (Ordered) Feature Library Purpose: The aim of this tutorial is to learn how to create and re-use a feature from the Feature Library. In this case we shall create a pair of positioned holes in a sheet metal part, although these could be created in either a sheet metal or part
491 total views, 1 views today